Handle bars /Risers
4 posters
Page 1 of 1
Handle bars /Risers
Ok so I'm new here .
Again this subject has probably been done to death ,opinions please slightly higher pulled back bars I'm hoping will stop my 51 year old neck from getting so sore .
The cables look long enough the clutch hose is probably ok but the Brake hose looks a bit short to accommodate the move .
Anyone done this and what pipes have you used ,any suggestions on bars ?
Tony
Again this subject has probably been done to death ,opinions please slightly higher pulled back bars I'm hoping will stop my 51 year old neck from getting so sore .
The cables look long enough the clutch hose is probably ok but the Brake hose looks a bit short to accommodate the move .
Anyone done this and what pipes have you used ,any suggestions on bars ?
Tony
Tonyw3088- Posts : 16
Join date : 2013-09-19
Age : 61
Location : Sunshine Coast Qld
Re: Handle bars /Risers
Is your Bandit a naked or an S model ?
Hammy- Posts : 4446
Join date : 2011-08-09
Age : 64
Location : The Rock
Re: Handle bars /Risers
It's an s mate . I'm thinkin 755-01 rentals then need extended brake and clutch hoses . Goin away for work now for two weeks so will check it out more when I'm home .
Tonyw3088- Posts : 16
Join date : 2013-09-19
Age : 61
Location : Sunshine Coast Qld
Re: Handle bars /Risers
Hey, I used two types. Have a look tho this thread >>>>Click Here<<<<Tonyw3088 wrote:It's an s mate . I'm thinkin 755-01 rentals then need extended brake and clutch hoses . Goin away for work now for two weeks so will check it out more when I'm home .
_________________
2007 Bandit 1250sa Silver
*Open airbox lid with K&N.
*Removed Secondaries.
*HealTech Gear Indicator w/tre "Advanced Timing Retard Eliminator is needed".
*Balanced TB's. My TPS was fine, but you should check yours.
*Arrow race headers with Yoshimura TRS.
*PC3 with the supplied map and these mod got 123hp with 115nm of torque.
*Neville Lush Racing custom tune = 130hp with 125nm at the Tyre (Standard 98hp/108nm).
My youtube channel (clickhere)
Re: Handle bars /Risers
I fitted barbacks so my V Strom handguards would clear the fairing. I had to get a longer brake hose from the joiner on the lower yoke, but the othe cables and clutch line fitted.
The barbacks are fantastc. Comfort plus. I got mine second hand, but they are SW Motech
Full writeup here http://kewwibike.blogspot.co.nz/2012/09/fitting-barbacks-to-gsf1250-bandit.html
The barbacks are fantastc. Comfort plus. I got mine second hand, but they are SW Motech
Full writeup here http://kewwibike.blogspot.co.nz/2012/09/fitting-barbacks-to-gsf1250-bandit.html
kewwig- Posts : 985
Join date : 2011-03-21
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|