Bearing Question

A bearing shop sells bearings .Thanks thats all .

No wait ,i remember, there was a question .
It sells ,bearings ,dust covers ,o-rings ,locktight and other things .
But do they sell the sharf that goes through the bearings ,like in suspension linkages ?

gus wrote:No wait ,i remember, there was a question .
It sells ,bearings ,dust covers ,o-rings ,locktight and other things .
But do they sell the sharf that goes through the bearings ,like in suspension linkages ?

I suspect you're fairly relaxed about now Gus

Its worth bearing in mind there are other bearing shops Gus.

Balls

So you dont know then .

2wheelsagain wrote:

gus wrote:No wait ,i remember, there was a question .
It sells ,bearings ,dust covers ,o-rings ,locktight and other things .
But do they sell the sharf that goes through the bearings ,like in suspension linkages ?

I suspect you're fairly relaxed about now Gus

+1 , ok Gus, give us another hint in the direction this is going.

What is a " Sharf " ?

Me thinks he means shaft. Not sure Gus. Don't think they do. What size?

I put new bearings in the aprilia suspension linkages .Now i notice one pin (sharft ) that goes through the bearingd is marked . Its either
reuse it or order a new one and wait ,and wait ect . If the sharfts are a common size just maybe a bearing shop sells them .I doubt it though .
Its only a length (50mm?) of metal ,maybe an enginering shop could cut me a piece of stainless tube till a new one turns up .
I'm also getting my sachs shock serviced .

gus wrote:I put new bearings in the aprilia suspension linkages .Now i notice one pin (sharft ) that goes through the bearingd is marked . Its either
reuse it or order a new one and wait ,and wait ect . If the sharfts are a common size just maybe a bearing shop sells them .I doubt it though .
Its only a length (50mm?) of metal ,maybe an enginering shop could cut me a piece of stainless tube till a new one turns up .
I'm also getting my sachs shock serviced .

How badly marked is it?
Maybe you can reuse it while you wait for a new one.

Fank Ewe.

Any engineering shop will nave some "bright mild steel" rod or tube hanging around. If its not a turned piece just cut to length and insert.

Yep, or 41/40