Puig Race screen, no instructions!

Righto, being a female, I thought a dark smoke racescreen would look nice on my bike, ordered and received today, from Solomotoparts.com, BUT.... no instructions!
Does anyone know where i could get some simple instructions? Im technically challenged!
Mine is a 2008 gsf1250 ABS....

Screens should all go on the same I would think. Remove the dash, you should not have to take out the inside (black) upper fairing but it might help first time you do it to see what is going on, there are 4 screws, two visible on the top of the upper fairing and two about at 10 and 2 oclock when looking at where the dash was - you should be able to tell from the screen where they are located. Careful with the wellnuts (the rubber gromet nut the screws go in, I try to get a finger up behind them when starting the screw, don't put too much pressure on them or they will push out the back, fall down never to be seen again as they are eaten by the cave dwelling nut and screw monster.

Peter ( Dekenai ) has a Puig screen from memory, he might be able to offer assistance if there are any little tricks.

Thanks so much, Barry, I've done it! Now fingers crossed I put back the instruments properly and that they dont rattle when i ride it.
As I can't figure out this site for uploading photos, I'm going to put one on theFB pge...
It looks rather hot now

No problems. Photo's are easy once you've done it a couple of times, same with brain surgery I'm told

There is link on here somewhere (opps been beat to the post pardon the pun) that give the process, it's all about hosting the photos on another site like Photo Bucket or my favorite Servimg.com .

Thankyou thank you Chris! Whoohoo I think I worked this out now....

[img][/img]

Side view...
Now that I look at these photos, the more i need to wash it, but weather is about to change..

[img][/img]

Now that you have worked out how to post pic's there will be no stopping you.

I see that you are also using Servimg as well. Here's a little hint, when you Host the picture Servimg will take you to the screen with the thumbnail picture and a couple of lines with COPY.



If you go down to the BBCode lines and press the second Copy button under "Image:" it will copy the link to your computers scratchpad (unfortunately I highlighted the Thumbnail copy line in this photo, you want the one under it). Then when you are writing the text in a message just hit Ctrl and V together and it will paste the link directly where you are at. Saves using the extra buttons at the top of the message area and you also don't get the [ img ] at the front and back of your photos.

BTW, the "Thumbnail Copy" is good for putting little photo's into your signature block.

Cheers